01
Program
Posted for NHX pallet 3 with probing macro enabled.
/sandbox
CNC handoff readiness runway · May 1, 2026 · 06:03
Setup Window
The last thirty minutes before spindle-on, made visible before it becomes scrap with paperwork.
View modeLaunch deck
CNC-7872 · A12-MAN-R7.NC
Hydraulic Manifold A12
DMG Mori NHX-4000 · qty 18 · Spindle-on target 06:45Handoff ownerM. Fischer
02
Revision
Drawing rev F loaded; model export says rev G notes changed.
03
Material
Two billets staged on cart B with cert packet.
04
Fixture
Tombstone jaws torqued, datum puck swept within 0.006 mm.
05
Tooling
T14 8mm long-reach ball missing sister offset and holder.
06
Gauging
Thread plug available; bore gauge due back from calibration bench.
07
Workholding Notes
Jaw step orientation photo attached to traveler.
08
First-Piece Plan
Critical bore CMM path ready; thread depth check pending.
09
Owner Signoff
Hold start until tool crib and QA clear the open gates.
What changed2 deltas
Drawing noteRev F: deburr general edges → Rev G: controlled break on port lands
Machinist must verify hand deburr limit before FAI.
Tool listT14 carbide ball 6mm → T14 carbide ball 8mm long reach
Offset and holder validation required.
First-piece planQA hold: gauge staging incomplete
CMM program A12_FAI_R7 plus bench thread plug
- Ø24 hydraulic bore true position
- M10x1.0 thread depth
- Port land edge break
Shift handoffA shift
05:51 · M. FischerDo not press cycle start until T14 is rebuilt and QA confirms bore gauge tag.